Testimonials
January 6, 2025,Passed CCIE EI LAB
January 6, 2025,Passed CCIE EI LAB,Desgin3 and DOO2,no changed,all questions is same,solutions is ok ...
1/6 Taiwan CCNP 350-401 Pass
I passed CCNP 350-401 this afternoon. There are about 6 new questions, and they are all multiple choice questions. The experimental questions are the same as these 6 questions, COPP, OSPF, VRF, NetFlow/SPAN/SLA, PortChannel, BGP address-family ...
2025.1.4 400-007 passed
I passed it yesterday and encountered 6 new questions, one of which was a picture-dragging question ...
January 2 CCNP 300-410 PASS
Most of the multiple-choice questions are covered, with 5 or 6 new questions LABS is fully covered, MGRE, AAA, SYSLOG7 It is recommended to read the question bank and read more books to understand the principles ...
350-701 Malaysia Passed
350-701 Malaysia Passed,All questions are fully covered, 100% passed ...
CCNA 200-301 Taipei, Taiwan Passed
The three lab questions are LACP + IPv4/IPv6 settings + VLAN division. The difficulty is not high and the complexity of the questions is low. I feel that about 15-20% of the other questions have not been seen before, but the questions are still the same. If you understand the knowledge points of the question, you will be able to answer it to a certain extent ...
Jiangsu Suzhou 12/21 300-410 PASS
There are 48 questions in total, including 3 drag-and-drop questions, 42 multiple-choice questions, and 3 experimental questions (MGRE-1, AAA, and SYSLOG-1). Only about 4 new multiple-choice questions are included in the question bank ...
350-401 12/16 Tokyo Pass
Tokyo 12/16 I passed it with trepidation, mainly because there were too many new multiple-choice questions. The lab questions were still the same 6 questions. It is worth noting that for the VRF question, you not only need to write a static route for tunnle 0, but also a static route for VLAN111 of SW11. Both of these static routes are for VRF Finance, otherwise SW11 cannot ping SW22. The other lab questions are about some parameter changes. And the OSPF aggregate route I know you all know how to write /16, area 40 range 10.40.0.0 255.255.0.0 /20, not area 40 range 10.40.0.0 255.255.240.0, because the original network segment was 10.40.50.0/24, so the aggregation should be 10.40.48.0 255.255.240.0. If you don’t understand this, I suggest you go back and re-study CCNA. 2 picture-dragging questions, both about Ansible, one of which is a new question, guess what. I prepared so many Jason's questions, but I didn't encounter any of them 50 multiple-choice questions, about 18-20 of which are not in the simplified questions, 5 or 6 of which are in the large-scale question bank, and about 10 questions are brand new ...
Implementing and Administering Cisco Networking Technologies, CCNA- 200-301 v 1.1, Pass, 16th December 2024
Implementing and Administering Cisco Networking Technologies, CCNA- 200-301 v 1.1, Pass, 16th December 2024 ...
FEEDBACK
No posts found.








